Audi A6 Triptonic No Tiene Repris

[julioa52]

Tengo un audi a6 cambiada hace 15 dias la caja cambios y el caudalimetro
cuando le parece no sube de vueltas y no tira nada como si se ahogara
de repente va bien y tira perfecto coin repris
que puede ser

[berto]

mira si tienes que hacer algún ajuste en la caja automática o algo parecido con el vagcom:
http://www.ross-tech.com/vag-com/cars/autotrans.html

Basic Settings:

Basic Settings should be performed on an Automatic Transmission after:

Engine replacement .

ECU replacement

Throttle Valve adjustment

TPS replacement

TPS adustment

TCM Replacement


--------------------------------------------------------------------------------

First, make sure there are no fault codes in the Auto Trans. Then, with the key in the on position, and engine OFF. Do not touch the accelerator pedal.

[Select]
[02 - Auto Trans]
[Basic Settings - 04]
Set Group to "000"
[Go!]
Press accelerator pedal all the way to the floor and count out loud 3 seconds.
[Done, Go Back]
Release the accelerator pedal.

It is normal for there to be no explicit instructions or changes on the screen when you do the above procedure. The transmission controller does not provide any feedback that it has been successfully performed.


--------------------------------------------------------------------------------

Note: In some newer Audi vehicles, you may find that Group 000 in Auto Trans. is unavailable. If that is the case, you should follow this procedure:


--------------------------------------------------------------------------------

First, make sure there are no fault codes in the Auto Trans. Then, with the key in the on position, and engine OFF. Do not touch the accelerator pedal.

[Select]
[01 - Engine]
[Basic Settings - 04]
Set Group to "063"
[Go!]
Press accelerator pedal all the way to the floor and count out loud 3 seconds.
[Done, Go Back]
Release the accelerator pedal.


--------------------------------------------------------------------------------

ATF Temperature, checking:

Automatic Transmission Fluid temperature needs to be within a specified range when checking the fluid level. See your Factory Repair Manual for the range for your vehicle.

[Select]
[02 - Auto Trans]
[Meas. Blocks - 08]
Set group to "005" (May be group 002 or 004 in some vehicles - again check the Repair Manual).
[Go!]
The value in field 1 should be ATF temp in °C.

[Andonigu]

He oido que hay caudas que no han durado ni 100km mira que este bien por si acaso.Algunos vienen de culo.

[julioa52]

es normal que a veces vaya bien y me parece que cuando has recorrido 10-15 kM O 15-20 MINUTOS es cuando va mal
DONDE HAY ALGUN TALLER ESPECIALIZADO EN ESTO
GRACIAS